Remove / Replace Procedure Platen Sensor PCA - Model T6215

Issue / Symptom:  Platen Sensor PCA removal was not included in Chapter 4 of the Maintenance manual.

The Platen Sensor PCA is located under the the left side of the printer mechanism, just above the Power Supply.

To remove the Sensor PCA, follow these steps:

1. Remove the Ribbon Platform.

2. Remove the Control Panel Assembly.

3. Unplug the Power Supply cable and the Hammer Bank cable from the Power Distribution PCA.

4. Lift the Print Mechanism, placing the Strut in the top and bottom detents to hold the Print Mechanism in a tilted position.

5. Disconnect the cables from the Platen Sensor PCA.

6. Remove the two screws (#6 Phillips) that attach the circuit board to the side frame and lift the board clear.