1) No PCL-II in the Printronix printer, so be careful with the
applications.
2) No PJL, so no jam recovery, or page level recovery is
possible.
3) If you accidentally leave pjl_support = TRUE or undeclared
you may get an unwanted PJL reset command.
(<ESC>%1234565x>CR><LF>).
Follow the steps below to configure the printer.
1) run npconfig.
2) Set up the device as 33 (network_address =xxx.yyy.zzz.www)
3) tcp_port_number =9100
4) pjl_supported = FALSE
5) snmp_enabled = FALSE
6) banner_trailer = TRUE or FALSE, both will work
7) jam_recovery = FALSE
8) setup_file = name*
*create an empty setup file to override the global entries.
The file must be unique, and unnumbered.
